What are the process standards used by Suzhou bend pipe processing manufacturers?

1.When processing bent pipes, it is necessary to inspect the surroundings of the task site and remove all debris that hinders the task and traffic. There should be no oil stains on the ground to prevent slipping. Workpieces should be stacked neatly and firmly to prevent collapse and injury to people.

2.Recheck if the protective installation on the pipe bending machine is incomplete. If it is not installed properly, do not drive for Suzhou pipe bending processing. Zhijiu reminds you that the pipe bending machine should have good grounding and electrical insulation, and the voltage should be stable.

3.Now we are inspecting the smooth parts of the Suzhou pipe bending machine. When there is a shortage of oil or no oil, we should add enough oil.

4.During the empty car test run, check whether the mechanical operation is normal and whether the electrical switches are sensitive and functional. After everything is normal, we will proceed with the task of Suzhou bend pipe processing manufacturer.

5.Mr. Zhijiuhu reminds that when two people work together, they should cooperate closely and coordinate equally. A dedicated person should be designated to operate the switch. During the bending process, it is not allowed to chat or laugh with others to prevent mistakes.

6.When the bending machine tool is in operation, the operator must not separate the machine tool.

7.During the task of the pipe bending machine, no one is allowed to be in the vicinity of the pipe bending stroke area, and protective warning signs are set up. When prying the pipe, stand firmly to avoid being injured by the pry bar slipping. The bending pipe processing operator can only stand on the outside.

8.Pay attention to the safety of the surrounding area when calibrating the pipe, and immerse the hammer in water before using it; Take a few minutes to avoid injuring people by removing the handle. Suzhou bend pipe processing factory is prohibited from wearing gloves when knocking on pipes.

9.When hot bending and correcting pipes by Suzhou pipe bending manufacturers, the face should avoid the pipe mouth to avoid hot sand spraying and injuring people due to pipe vibration. When pouring yellow sand, the pipe should be hung firmly to avoid tipping. There should be no oil stains inside the pipe, and dry yellow sand should be used.

10.When using gas for bend pipe processing, the furnace door should be opened first, and the accumulated gas should be blown off before ignition.